Create an FTP Server on Windows 10 to be accessed via an External Network

create an ftp server on windows 10 to be accessed via an external network - Create an FTP Server on Windows 10 to be accessed via an External Network

After we’ve pc, it can be accessible inside a Local Network. But if you want to entry the hosted information remotely, it brings in some limitations. To overcome these limitations and make this hosted FTP Server accessible via the Internet, you may need to tweak some settings additional. However, configuring an FTP Server to be out there via the Internet on a Windows 10 pc can be a few of a job. We will be discussing it right now.

Create FTP server to be accessed via exterior community

We will be configuring our routing settings for this.

Start by, opening the Command Prompt command line by looking for cmd within the Cortana search field or hit WINKEY+R to launch the Run utility and sort cmd and hit Enter.

Now, sort within the following command to get the main points about your network-

create an ftp server on windows 10 to be accessed via an external network - Create an FTP Server on Windows 10 to be accessed via an External Network

ipconfig

You want to now be aware down the Default Gateway IP Address. It will be within the format of 192.xxx.xxx.xxx the place the variety of digits in every block is most to three.

Now, open the default internet browser put in on your pc and sort in that tackle within the tackle bar and hit Enter.

When you get a immediate for the credentials, enter the username and password on your router and log in.

1548046660 590 create an ftp server on windows 10 to be accessed via an external network - Create an FTP Server on Windows 10 to be accessed via an External Network

Navigate to the WAN or NAT settings and search for for Port Forwarding.

Now, you want to configure the port forwarding settings as the next settings,

  • Service Name – Name it something you want.
  • Port Range – You want to use 21 because the port quantity solely.
  • Local IP – Get the IPv4 worth from the outcomes you get from the ipconfig command above and enter it right here.
  • Local Port – You want to use 21 once more solely. No different worth ought to be used.
  • Protocol – Use TCP because the protocol to be used.

Once executed, you want to save and apply the adjustments.

This ought to lastly allow accessibility of your FTP Server from an exterior community via the Internet on each Client and Server finish.

But earlier than all this, you want to create and configure an FTP Server on Windows 10.

Leave a Comment